Lake-monitors Flow Transmitters User Manual download pdf (Page 36)

Connectors

Standard flow sensors are prewired with 4-wire Hirschmann-type DIN

connectors which consist of a male section as shown in Illustration 10

and a female section as shown in Illustration 11. In order to make

the user connections, the screw terminals located inside of the female

section must be accessed.

To open the female

section, first

remove the screw

and then lift the

connector portion

out of the casing by

inserting the head

of a screwdriver

into the slot marked

for that purpose.

Illustration 12

shows the disas-

sembled female

section. The screw

terminal connec-

tions can be seen

on the piece located

at the far right side

of the illustration.

Alternate connectors are available on a custom basis. Nearly any

type of commercially available electrical connector may be installed

on a Lake Monitors Flow Transmitter. If an alternate connector is

required, please consult the Lake factory.

Page 36 / Flow Transmitters / Lake Manual

Illustration 10 Illustration 11

Illustration 12

1 2 ... 31 32 33 34 35 36 37 38 39 40

No comments

Lake-monitors Flow Transmitters User Manual Page 36